How to carry out a factory reset on CSM-1

[KB5072]

This article applies to the following products:

There are two ways to reset the base unit to default settings:

With the webinterface:

  1. Log in to the ClickShare web interface
  2. Click the Maintenance tab (1) and then click Configuration (2).
  3.  Click on Load Default Settings to return to the factory defaults (3).

With the reset button:

  1. Start up the Base unit.
  2. When Barco logo appears, press the reset button (bottom side of the Base unit) Press this button until the Barco logo disappears and the LEDs are blinking red/white for at least 10 seconds.
  3. Release the button.
    The Base unit will restart with its default configuration

 
Restoring to factory defaults will require a repairing of the Buttons used with this Base Unit.
 

 

Properties

[KB5072]

Last updated Sep 28 2017

Was this information helpful?