How to carry out a factory reset on CS-100(Huddle), CSE-200(+) and CSE-800

[KB5066]

This article applies to the following products:

There are two ways to reset the Base Unit to default settings:

With the web interface:

  1. Log in to the Configurator.
  2. Click Support & UpdatesTroubleshoot.
  3. Click Reset to factory defaults.
    The following message is displayed: This action will remove all settings of the Base Unit and replace them with the default settings. Are you sure you want to continue?
  4. If you want to continue, click Yes, remove all settings otherwise click No, I changed my mind.
    When yes is clicked, the system starts a reboot. 

With the reset button:

  1. Disconnect the ClickShare power supply.
  2. Press and hold the reset button on the back of the ClickShare with a paperclip.

    For CS-100 (H) & CSE-200



    For CSE-200+



    Note

    For the CSE-200+, one needs to hold the reset button until the Base Unit's front LED flashes red-white. This can take up to one minute.


    For CSE-800



  3. While holding the reset button, reconnect the ClickShare’s power supply.
  4. Hold the reset button until the red-white flash of the power button flashes white.

Properties

[KB5066]

Last updated Mar 30 2020

Was this information helpful?