There are two ways to reset the Base Unit to default settings:
Restoring to factory defaults will require re-pairing of the Buttons used with that Base Unit.
- Log in to the Configurator.
- Click Support & Updates → Troubleshoot.
- Click Reset to factory defaults.
The following message is displayed: This action will remove all settings of the Base Unit and replace them with the default settings. Are you sure you want to continue?
- If you want to continue, click Yes, remove all settings otherwise click No, I changed my mind.
When yes is clicked, the system starts a reboot.
- Disconnect the ClickShare power supply.
- Press and hold the reset button on the back of the ClickShare with a paperclip.
For CS-100 (H) & CSE-200
For the CSE-200+, one needs to hold the reset button until the Base Unit's front LED flashes red-white. This can take up to one minute.
- While holding the reset button, reconnect the ClickShare’s power supply.
- Hold the reset button until the red-white flash of the power button flashes white.
Last updated Jun 14 2022