General
The source input panel is located at the back of the projector..
| Name | Pcs | Description | Purpose |
| DMX IN | 1 | DMX 512 input | For Projector Control |
| DMX OUT | 1 | DMX 512 output | For Projector Control |
| RS-232 | 1 | 9–pin DB9 connector | For Projector Control. Allows for wired remote control and monitoring of many projector functions used in installation environments |
| Sync | 3 | BNC Sync Port IN/OUT; Bidirectional mini-DIN (1x 3D sync Out, and 2x Sync In/Out) | For Projector ControlThis is mainly used in multiple projector installations with requirement of synchronization between the units |
| Trigger | 3 (one in front, two on rear panel) | 12VDC - 0,5A (6W)
| For Controlling Peripherals, like motorized screens, curtains etc. Give 12V output when projector are switched on. NOTE Disconnect the projector power cable before connecting or removing the trigger cable |
| RC | 1 | Jack connector for wired remote | For Projector Control |
| USB | 3 | USB 2.0 type A, 4 pin( 2x Rear and 1x Front) | For Software upgrade |
| LAN | 1 | Standard RJ45 connector | For Projector Control |
| DP | 2 | Standard display port | For Projector Input |
| DL-DVI-D | 2 | Dual DVI-I 1.0 (DVI_D Functionallity). | For Projector Input. These connectors can also be used to form one uniform image by feeding half of the image into each connector. HDCP compliant for sources up 165 Mhz |
| HDMI | 1 | Standard HDMI 2.0 | For Projector Input |
| HDBaseT | 1 | Standard RJ45 8P8C Connector | For Projector Control |
| SDI | 2 | SDI1 is Input, SDI 2 is pass through. (out) | For Projector Input |
