To switch on your display

While in standby mode, press the right-most front key 2 times.

Note: While starting up, the orange and white power LED are both lit, until the display is fully operational.

Note: Make sure that the rocker switch on the power supply (next to the mains input) is in position “I” to use your display.

To switch off your display

1. Activate the shortcut bar by pressing any of the front keys (except for the left-most front key, which would activate I-Luminate).
2. Press the front key under the standby icon ().
3. Press the front key again to confirm.

Note: In case of a power outage recovery, your display will always start-up in the power mode it was in before the power interruption (i.e. stand-by or on). This protects your display against inadvertent image retention problems.