About I-Luminate default mode

The default I-Luminate mode defines the initial mode when I-Luminate is switched on.

There are 3 I-Luminate modes:

• Screen: I-Luminate is applied on the entire screen without any overlay.
• Small film: I-Luminate is applied on the entire screen with an additional white rectangular overlay, simulating a light box for use with classic radiological films. The size of the white overlay corresponds to the dimensions of small radiological films.
• Large film: I-Luminate is applied on the entire screen with an additional white rectangular overlay, simulating a light box for use with classic radiological films. The size of the white overlay corresponds to the dimensions of large radiological films.

To set the default I-Luminate mode

1. Bring up the OSD main menu.
2. Navigate to the Configuration > I-Luminate menu.
3. Enter the Default mode submenu.
4. Select Screen / Small Film / Large Film as desired and confirm.