About power management:

The display has 1 key:

• Main power switch (to switch off all power to the display).

The display can go in three different statuses:

• On Line: The display is in this status when the video input is good and an image is displayed. In this status all circuits are powered and the power consumption depends from the backlight level.
• Standby: The display is in this status when the video input is gone, the backlight goes off. All circuits remain powered but the power consumption is low. Standby mode is automatically enabled.

To change the status of your display:

1. Activate the power through the switch located on the back side of the display.

   If no valid input is detected, the display will go into standby mode.

To switch on/off your display:

1. While your display is on, switch off the power with the main power switch.

   or

   While your display is off, switch on the power with the main power switch.