6.8.1 Displaying and Programming addresses into the RCU

Displaying the Projector Address on the Screen.

  1. Press Address key (recessed key on the RCU) with a pencil.

    The projector's address is displayed on the local LCD screen.

Note: To continue using the RCU with that specific address, it is necessary to enter the same address with the digit buttons (address between 0 and 9) within 5 seconds after pushing the address key. For example : if the Address key displays projector address 3, then press "3" digit button on the RCU to set the RCU's address to match the projector's address. Do not press 03. This will address the remote control to '0' and control all projectors in the room. If the address is not entered within 5 seconds, the RCU returns to its default address (zero address) and controls all projectors in the room.
How to Program an Address into the RCU?
  1. Press the Address key (recessed key on the RCU) with a pencil.

  2. Enter the address with the digit buttons within 5 seconds after pushing the address key.

    Note: That address can be any digit between 0 and 9.
Tip: The LED on the remote control must lit up while pressing a digit key. Otherwise the address is not entered in the remote control.