13.8.23 Warp board and values reset

What can be done?

With some extreme warp values the hardware of the warping can get stuck. With only a hard reset of the board, it starts up with the same extreme values and get stuck immediately. So that is not the solution. Therefore, while executing a hard reset, the warp values are reset at the same time so that the board can start up.

How to reset board and values

  1. Press Menu to activate the menus and select Alignment → Warping → .Warp board and values reset.

    Image 13–94 Main menu, alignment
    Image 13–95 Alignment, Warping
    Image 13–96 Warp board and values reset
  2. Press ENTER to reset the board and the current warp values.