General

Similar to the Destination Buttons the Layer buttons create a selection for further actions.

Buttons are as standard in the same select mode as the destinations, latch on, latch off.

A range of actions can be performed with this selection:

• Assign a Source file via the Assign buttons from the Source bus.
• Layer Transition or Cut via the Red Layer Executors to the right of the Layer button row.
• Freeze via the Blue Layer Executors to the right of the Layer button row.
• Arm via the Green Layer Executors to the right of the Layer button row.
• Match Program via the Green Layer Executors to the right of the Layer button row.

A layer selection via the console has the same actions available as are available in the Event Master Toolset, just in a more hands-on direct way.

If a layer is not on preview or program, pressing the button will add the layer to preview and select it for modification.

Once on PVW only the clear button in the GUI or on the right side of the controller will remove the layer from PVW.