About the input boards
The projectors have a Control and Communication panel, as well as up to two input slots (amount depends on model). These input slots are marked internally as “L1” and “L2”.
The input selection commands in the basic DMX chart only applies to the input module in slot L1.
The input selection commands in the extended DMX chart are as follows:
- Use channel 2 to target the input module located in slot L1
- Use channel 14 to target the input module located in slot L2 (if available).
- 1
- Slot L1, here filled with the Quad combo Input MKIII module
- 2
- Slot L2, here filled with the Quad DP 1.2 Input module