7.3 Switching to ready mode

How to switch to ready mode

  1. Press and hold the Power on/off button for 3 seconds on the local keypad, or press the Power Off button on the remote control.

    The projector goes to Ready mode. The after-cooling cycle will start (about 30 seconds). During this period the Power on/off button will blink. Once the after-cooling cycle has ended, the projector will be in ready mode and the Power on/off button will be lit WHITE.

    Image 7–4
Note: While in ready mode, you can still navigate through the menus and set a limited amount of parameters.

Depending on the power savings settings of your device, if left untouched the projector will eventually go into standby or eco mode.