General

Three types of transitional triggering are available:

All-trans

All-trans (Transitions All) is the way to start a timed transition of Destinations. It transitions the set up pre-view into program.

In the case a transition is not completed it can be reversed.

A manually started transition can be finished with an All-Trans command and an All-Trans command can be finished with the T-bar.

Note: Only selected destinations are affected. Unselected destinations are not affected by the transition.

Cut

Cut perform the same action as the All-Trans but with zero time.

Layer Trans

Layer Trans transitions the selected layer in any Destination, whether it is selected or not. This button is placed on the side of the Layer bus to the left of the console. It can also be found in the GUI, below the workspace.