3.1 On/off switching

Note: The procedures below consider that DC power is supplied to the display. Please check the status of the power mode LED to verify that your display is supplied with DC power (see “Power status LED ”).
Note: When the DC power is supplied to the display, all LEDs of the front keyboard will turn on for 1 second. After this, the front keyboard calibration is performed (all white LEDs will turn off and the central LED will turn orange).

Do not touch the front keyboard during calibration (less than 4 seconds). When the calibration is complete, the front keyboard is available and can be used (the central LED will turn steady green or blinking green / orange).

To switch on your display

With the front keyboard:

  1. Press and hold (3-4 seconds) the key until the entire front keyboard starts blinking.
  2. While the front keyboard is blinking, release the key again (within 2 seconds, to avoid a keyboard re-lock) and the display will switch on.

With the rear keyboard:

  1. Press and hold (3-4 seconds) the center button until the entire front keyboard starts blinking..
  2. While the front keyboard is blinking, release the center button again (within 2 seconds, to avoid a keyboard re-lock) and the display will switch on.
Note: When the keyboard backlight lights up, the power mode LED will turn full green indicating that the display is switching on and the logo will be visible for a few seconds.
To switch off your display

With the front keyboard:

  1. Unlock the front keyboard (see “Front keyboard locking/unlocking”).
  2. With the keyboard unlocked, press and hold (3-4 seconds) the key until the entire keyboard starts blinking.
  3. While the front keyboard is blinking, release the key again (within 2 seconds) and the display will switch off.

With the rear keyboard:

  1. Press and hold (3-4 seconds) the center button until the entire front keyboard starts blinking.
  2. While the front keyboard is blinking, release the center button again (within 2 seconds) and the display will switch off.
Note: When the power is supplied to the monitor, all LEDs of front keyboard are turned on for 1 second. After this time the front keyboard calibration is performed (all white LEDs are turned off and the central LED is turned yellow).

Don’t touch the front keyboard during calibration (less than 4 seconds). When the calibration is completed, the front keyboard is available and can be used (the central LED turns to steady green or blinking green/yellow).