2.4 Unpacking and inspection

General

Before shipment, all the devices were inspected and found to be free of mechanical and electrical defects. As soon as the devices are unpacked, inspect for any damage that may have occurred in transit. Save all packing material until the inspection is completed. If damage is found, file claim with carrier immediately. The Barco Sales and Service office should be notified as soon as possible.

Unpacking

At delivery, all devices are packed in a shipping case. Place the shipping case of the device on a stable (solid), flat and insulated support during all the unpacking. Open the case from the top. Remove the device that is packaged in an antistatic bag. Check the box content after unpacking.

Note: After unpacking let the device acclimate to the room temperature which must be higher than 0°C (32°F) and lower than 40°C (104°F). Neglecting this may result in startup failure of the device.
Note: When shipping a PDS-4K presentation switcher in a Barco-supplied case, make sure that the rear connector protectors are installed to prevent damage.
Tip: Save the original shipping case and packing material, these will be necessary if you ever have to ship your device. For maximum protection, repack your device as it was originally packed at the factory.
Box content

It is recommended to verify if all accessories are included in the box.

The following accessories are included with the PDS-4K of choice:

Mechanical check

This check should confirm that there are no broken parts and the unit is free of dents or scratches. Notify the Barco Sales representative as soon as possible when this is not the case.


[1] Not included in the chinese variants

[2] Only included in the chinese variants