Environment
Do not place this equipment on an unstable cart, stand, or table. The product may fall, causing serious damage to it.
To prevent risk, personal injury, and PDS-4K screen switcher damage
Please read this chapter carefully. It contains important information to prevent personal injury while installing the PDS-4K screen switcher. Furthermore, it includes several cautions to prevent damage to the device. Ensure that you understand and follow all safety guidelines, safety instructions and warnings mentioned in this chapter before installing the PDS-4K screen switcher. After this chapter, additional “warnings” and “cautions” are given depending on the installation procedure. Read and follow these “warnings” and “cautions” as well.
- Read these instructions.
- Keep these instructions.
- Heed all warnings.
- Follow all instructions.
- Only trained technicians may install an PDS-4K screen switcher.
- Installation of the PDS-4K screen switcher must be done in a dust free area.
- Only use attachments/accessories specified by the manufacturer.
- CAUTION: Troubleshooting must be performed by a trained technician. To reduce the risk of electrical shock, do not attempt to service this equipment unless you are qualified to do so.
- Refer all servicing to qualified service personnel. Servicing is required when the system has been damaged in any way, such as liquid has been spilled or objects have fallen into the system, or the system has been exposed to rain or moisture, does not operate normally, or has been dropped.
- FRAGILE: The PDS-4K screen switcher is fragile. Handle the unit with care at all times.
- Do not remove the top cover during normal operation. Removal of the top cover exposes dangerous voltages. To avoid personal injury, do not remove the top cover. Do not operate the unit without the cover installed.
- During maintenance operations, always switch off the unit and unplug the power cords before removing the cover, unless otherwise stated.
- Always wear a wrist band which is connected to the ground while handling the ESD sensitive parts.
- Wear insulating gloves during the execution of the installation and maintenance actions to avoid short-circuit.
- Be careful never to drop anything into the PDS-4K screen switcher assembly during the procedure. The fall of a tool or a spare part in the unit could have catastrophic consequences when the system restarts.
- Be careful to always follow strict procedures during maintenance operations (spare parts replacement).
- This product is intended to operate from a power source that will not apply more than 240 volts rms between the supply conductors or between both supply conductor and ground. A protective ground connection by way of grounding conductor in the power cord is essential for safe operation.
- This product is grounded through the grounding conductor of the power cord. To avoid electrical shock, plug the power cord into a properly wired receptacle before connecting to the product input or output terminals. A protective-ground connection by way of the grounding conductor in the power cord is essential for safe operation.
- Use only the power cord and connector specified for your product. Use only a power cord that is in good condition. Refer cord and connector changes to qualified service personnel.
- To avoid fire hazard, use only the fuse having identical type, voltage rating, and current rating characteristics. Refer fuse replacement to qualified service personnel.
- Replace spare parts only with the same or equivalent type recommended by the manufacturer.
- Save the original shipping carton and packing material. They will come in handy if you ever have to ship your equipment. For maximum protection, repack your set as it was originally packed at the factory.
- Rated maximum ambient operating temperature, ta= 40°C (104°F).
- To avoid explosion, do not operate this product in an explosive atmosphere.
