About the projector address

The Remote Control supports individual addressing of multiple projectors. The remote receiver on the projector can be set with a specific number from 00 to 99, and the projector only responds to the IR remote set to the same number. The default ID code of the RCU (also known as the broadcast address) is 00. This specific address allows the RCU to control all projectors within its effective range.

How to set the projector address on the RCU

1. Keep ID Key pressed in.

2. After few seconds, enter the address with the numeric keys while keeping the ID Key pressed in.

   

   Tip: Always enter two digits. E.g. for address 2, enter 02.
3. Release the ID Key.