About web control center

Web control panel allows the user to configure various projector settings using a web browser from any personal computer or mobile devices.

System requirement

To use the web control panel, make sure your devices and software meet the minimum system requirements.

• RJ45 cable (CAT-5e) or wireless dongle
• PC, laptop, mobile phone, or tablet installed with a web browser

• Compatible web browsers:

  • Internet Explorer 11 or higher version
  • Microsoft Edge 40 or higher version
  • Firefox 57 or higher version
  • Chrome 63 or higher version
  • Safari 11 or higher version

• Operating system of the mobile devices:

  • iOS 10 or higher version
  • Android 5 or higher version

Accessing the web control panel

When network is available, connect the projector and the computer to the same network. Use the projector address as the web URL to open the web control panel in a browser.

1. Check the projector address using the OSD menu.

   • In a wired network, select Communication > Network Setup > Ethernet.
   • Make sure DHCP is enabled.
   • Select IP Address
   • In a wireless network, select Communication > Network Setup > Wireless > IP Address.

2. Open a web browser and type the projector address in the address bar and confirm.

   The web page redirects to the web control panel.

Directly connect the projector to a computer

When a network is not available to you, connect the projector to you computer directly using a RJ-45 cable, and configure the network settings manually.

1. Assign IP address to the projector

   • In the menu, select Communication > Network Setup > Ethernet.
   • Turn off DHCP, and manually set the projector’s IP Address, Subnet Mask, and Gateway.
   • Press Enter to confirm the settings.

2. Assign an IP address to the computer

   • Set the Default Gateway and Subnet Mask of the computer to match the projector.

   • Set the IP address of the computer to match the first three numbers of the projector.

     For example, if the projector IP address is 192.168.000.100, set the computer IP address to 192.168.000. xxx, where xxx is not 100.

3. Open a web browser and type the projector address in the address bar.

   The web page redirects to the web control panel.