About network setup

Configure the projector’s network settings.

Ethernet

Configure the projector’s Ethernet settings when connecting to a wired network using an RJ-45 cable.

• LAN Interface: Specify the LAN interface to RJ-45 or HDBaseT.
• MAC Address: Display the MAC address. (Read only)
• Network Status: Display the network connection status. (Read only)
• DHCP: Turn on DHCP to automatically acquire IP address, subnet mask, gateway, and DNS.
• IP Address: Assign the projector’s IP address.
• Subnet Mask: Assign the projector’s subnet mask.
• Gateway: Assign the projector’s gateway.
• DNS: Assign the projector’s DNS.
• Apply: Apply the wired network settings.

Reset

Reset all network settings to default factory values.