About remote setup

Configure the settings of the Infra-Red (IR) remote control.

Remote code

Assign an remote code from 00 to 99 for the remote receivers on the projector. The projector only responds to the IR remote control set with the same remote code.

Remote receiver

Set the remote receiver for the projector to control the communication between the projector and the IR remote.

• Front: Enable or disable the front remote receiver.
• Top: Enable or disable the top remote receiver.
• HDBaseT: Select On to set the HDBaseT terminal as the remote receiver.

User Button 1 / User Button 2

Assign a function to the User 1 / User 2 button on the remote control. It allows you to use the function easily without going through the OSD menus. The available functions for the User 1 / User 2 button are:

• Freeze Screen
• Blank Screen
• Save to User
• PIP/PBP
• Aspect Ratio
• Show Message
• User Data
• Network Setup
• Projector ID
• Orientation
• Custom RGBCMY
• Multi-Projection
• Reset Selective