Location
- Navigation side bar:
- Central work window: or
- Right panel:
8.10.6.12 Time setting
About time setting
The internal time of the unit can either be set manually or synced to a local or network NTP time server.
How to set
Is there more than one unit in the system?
- If yes, click on the header of the desired unit (reference A or B) in the central work window. Go to next step.
- If no, go to next step.
Image 8–47 Example where the host unit is selected - A
- Host unit selection area
- B
- Client unit selection area
How must the time be set?
- In case of manual, click the radio button before (reference 33). Go to step 4.
- In case of synced, click the radio button before (reference 34). Go to next step.
Image 8–48 - 1
- Category selection
- 15
- Temperature diagnostics table
- 16
- Unit ID input field
- 17
- Flash unit front panel toggle
- 18
- Lock unit front panel toggle
- 19
- Increase unit front panel brightness
- 20
- Decrease unit front panel brightness
- 21
- Solid black signal on invalid video toggle
- 22
- Front panel brightness input field
- 23
- Front panel brightness slider
- 24
- Active input ports drop down
- 25
- Refresh time settings button
- 26
- NTP server status
- 27
- NTP server input field
- 28
- Calendar menu
- 29
- Manual date input field
- 30
- Manual system time input field
- 31
- Manual time zone drop down
- 32
- Manual local time input field
- 33
- Manual time settings radio button
- 34
- Automatic time settings radio button
- 35
- Use NTP server toggle
Must an server be used?
- If yes, enable the checkbox (reference 35, Image 8–48) and enter the address of the desired server (reference 27, Image 8–48). Go to step 5.
- If no, go to step 6.
- Fill out the information of the manual time (reference 28 through 32, Image 8–48).
- Click the refresh icon (
) after (reference 25, Image 8–48) to load the changes. - Click the save icon (
) in the header.