About presence sensor

The presence sensor detects if somebody is present in front of the display (within a range of approximately 90 cm) and will set the backlight to a minimum if nobody is present after a time-out (configurable in the OSD menu by the presence sensor timer). When a person is detected, the display will switch to normal operation again.

Note: The presence sensor cannot distinguish the difference between a person and an object. This means that for instance, a high chair might also be detected and could prevent the backlight to be set to a minimum.

Note: Changing the display position (height, tilt, swivel or pivot) might influence the detection range of the presence sensor.

Note: DPMS mode must be enabled before presence sensor can be enabled. See “DPMS mode”.

To enable/disable the presence sensor

1. Bring up the OSD main menu.
2. Navigate to the Power Management menu.
3. Enter the Presence Sensor(PS) submenu.
4. Select Enabled/Disabled as desired and confirm.

To adjust the presence sensor timer

1. Bring up the OSD main menu.
2. Navigate to the Power Management menu.
3. Enter the PS Timer submenu.
4. Set the presence sensor timer value as desired and confirm.