3.2 Basic Workflow

Before using CSE-200

  1. Unpack the ClickShare components and accessories from the box.

    For a detailed overview of the content of the CSE-200 box, see “About the CSE-200”.

  2. Install the Base Unit in the meeting room using one of the 2 possible installation methods.

    For more information on the installing procedures, see “CSE-200 Installation”

  3. Connect the video signal between the Base Unit and the display.
  4. Connect the audio from the Base Unit to the meeting room's sound system (only required for audio via jack or SPDIF).
  5. If configuration via a network is needed, connect a network cable between the Base Unit and the local network (if not yet done to power the Base Unit).

  6. Connect the Base Unit to the mains power (optional if Ethernet supports PoE+).

    For more information, see “Power connection”,

  7. If desired, configure CSE-200 via the Configurator.

    For more information on the different ways to configure CSE-200, see “CSE-200 Configurator”

Tip: For more information on using CSE-200, refer to the CSE-200 User Guide. This manual can be found on Barco's website www.barco.com/clickshare.