4.18 KVM switch

About KVM switch

The Nio Color 5.8MP can be used in dual workstation setup with KVM switch. This allows the display to be connected to two different workstations and control both with a single keyboard and mouse connected to the display. Switching the video and control signals between the two workstations is done with the KVM switch, which must be enabled as explained below.

Note: Your display system must be specifically set up and configured for KVM input switching. For instructions, see “Dual workstation setup with KVM switch”.
To enable/disable the KVM switch
  1. Bring up the OSD main menu.
  2. Navigate to the Image Settings menu.
  3. Enter the KVM Switch submenu.
  4. Select Enabled/Disabled as desired and confirm.
Note: When enabling the KVM switch, the Image Source menu will be inaccessible.
To switch KVM inputs
  1. Bring up the OSD main menu.
  2. Navigate to the Image Settings menu.
  3. Enter the KVM Input Selection submenu.
  4. Select input 1 or input 2 as desired and confirm.
Note: When switching KVM inputs, the video is switched instantly while switching the USB signal might take a little longer (up to 2 seconds).
Note: KVM input switching can also be done more quickly via the shortcut bar. See “KVM input switching”.