About I-Luminate

When I-Luminate is switched on, the LED backlight of the display is boosted to the maximum value, creating the highest possible luminance.

There are 3 I-Luminate modes:

• Screen: I-Luminate is applied on the entire screen without any overlay.
• Small film: I-Luminate is applied on the entire screen with an additional white rectangular overlay, simulating a light box for use with classic radiological films. The size of the white overlay corresponds to the dimensions of small radiological films.
• Large film: I-Luminate is applied on the entire screen with an additional white rectangular overlay, simulating a light box for use with classic radiological films. The size of the white overlay corresponds to the dimensions of large radiological films.

To use I-Luminate

• Press the left-most front key during normal operation (while the OSD menu is not active) to switch on I-Luminate in the default set mode.
• With I-Luminate switched on, press second left-most key (front key ‘2’ indicated on “At a glance”), to cycle through the different I-Luminate modes (Screen → Small Film → Large Film → ...)
• Press the left-most front key again at any time to switch off I-Luminate and return to normal mode.

Note: To set the default I-Luminate mode (i.e. the initial mode when I-Luminate is switched on), see “I-Luminate default mode”.

Note: To set the position of the white rectangular overlay in Small Film and Large Film mode, see “I-Luminate film position”.

Note: I-Luminate switches off automatically after 1 minute.

Tip: I-Luminate can also be enabled and configured in the Intuitive Workflow Tools. See the Barco “Display Controller and Intuitive Workflow Tools” user guide on the included documentation CD, or at www.barco.com/support.