Prerequisites
Before starting to set up your Event Master series processor, please review the following prerequisites:
- Ensure that you are familiar with the Event Master devices, including system control means and features. For details, please refer to Chapter “General”.
- Ensure that you are familiar with front panel menus of the Event Master processors. For details on all menus, please refer to Chapter “Front Panel Menu orientation”.
- Ensure that you are familiar with front panel menus and Event Master Toolset Software. For details on Event Master Toolset Software, please refer to Chapter “EM GUI orientation”.
- Ensure that the unit is physically secured on a rack or is placed on a flat surface with a stable support. If the unit is installed on a rack, it is mandatory that the rear brackets are also installed. For details, please refer to the section “Rack-mount procedure”.
- Ensure that all hardware is properly installed, and that all sources, displays and peripherals are properly connected. For details concerning Event Master series processor connectors, please refer to the unit rear panel description in the section “Rear panel”.
- Connect the AC power to the unit. If power redundancy is desired, connect power to both power plugs.
- Make sure that the Event Master series processor is connected to the Ethernet local network in order to communicate with the PC where the control software is installed.