Since firmware 02.17, when 2 displays are attached, we show signage on the primary display and the wallpaper on the other.
For firmware 02.14 up to 02.16, the signage content on 2 displays is observed to occur in 2 situations:
- The resolution and/or aspect ratio of the 2 displays are different
- There is a time delay in rendering the content on the 2 displays
Digital Signage on 2 displays is only available on the CX-50 Gen2 and this from FMW 2.14 onwards.
1. The resolution and/or aspect ratio of the 2 displays are different
When the resolution and/or aspect ratio of the 2 displays are different, the content on both screens can differ when the content does not scale automatically to match the display resolution and aspect ratio.
This can happen both in Extended and in Clone mode.
2. There is a time delay in rendering the content on the 2 displays
The signage content on the 2 displays is not synchronized. This means that the content of the 2 displays may get out of sync after a while.
Workaround: Reboot the Base Unit.
