How to setup the ClickShare CSE-800 Base Unit?
Numero dell'articolo: [9953]
- Take the Base Unit and the accessories out of the box.
- Screw the antennas on to the connectors at the back of the Base Unit.
- Connect the Base Unit to the meeting room display using an HDMI™ cable.
- Connect the Base Unit to the network using ethernet cable
- Connect the power cable to the Base Unit, this will start up the device. The Base Unit LED changes from static red to flashing white and then to static white.
- Configure the Base Unit if required by accessing the ClickShare Configurator (how to: see KB2324).
- Pair your Buttons to transfer the configuration and update the Button firmware (how to: see KB5924).
- All set! Your Base Unit is now ready to use, and you will see the ClickShare wallpaper on your meeting room display.
Connect the ClickShare Button or launch the ClickShare Desktop App on your PC/Mac and share content to the meeting room display (how to: see KB2898 and KB2607 respectively).
Proprietà
Ultimo aggiornamento 5 feb 2026
