A.2 Configuring the device with Pulse Prospector

Caution: Barco discourages configuring the system and users to match older versions of the software. The default user names, passwords and PIN codes are widely known. Barco cannot be held accountable for breaches caused by using well-known default credentials on purpose. Similarly, Barco discourages to enable or disable toggles that make it easier for unauthorized agents on the network to gain control over the device, possibly interrupting use of the device.
How to configure for Pulse Prospector
  1. Power on the device for the first time.
  2. Perform the initial setup. For more info, see “Initial setup”.

  3. Enable unsecured access. Do this by enabling the following:

    • Unencrypted API access
    • Unsecured HTTP

    For more information, see “Network connections”.

  4. Manually recreate the legacy accounts. Use the following process to create an account: “User accounts”

    User nameGroupPasswordPIN code
    userEnd Userdefault123469905
    poweruserPower Userdefault1234292920
    adminAdministratordefault1234297081
    Note: The legacy service user cannot be recreated.
  5. Enable PIN authentication. For more info, see “System-wide settings”.

  6. If the local setup requires the system to not have passwords (e.g. legacy tool Projector Toolset), disable the Authentication required toggle. For more info, see “System-wide settings”.

    Note: It is important to note that when the password setting is disabled,
  7. Make sure the toggle to upload custom test patterns is enabled. For more info, see “Uploading new test patterns”.