Quick setup
The following steps describe briefly how to setup your HDX projector in a table mount front projection. Note that each step refers to a corresponding procedure, which is more detailed and illustrated.
- Install the batteries of the remote control. See “Pulse RCU battery installation”
- Place the projector on a solid table in front of the screen at the expected throw distance. Ensure that the projector is installed at right angles (horizontally and vertically) with the screen. See “Projector configurations”.
- Select and install an appropriate lens, which covers the throw ratio ( = screen size / projector screen distance). See “Lenses”.
- Connect the projector with the local power net. See “Connecting the projector with the power net”.
- Connect your source to the appropriate input module. See “Input source connections”.
- Switch ON the projector. See “Power on projector”.
- Select the input slot to which the source is connected. Do this by pressing the numeric key on the remote control unit or on the local keypad, See “Source selection”.
- Zoom and shift the lens until the image is properly projected on the screen, Do this by using the “ZOOM” and “FOCUS” key on the remote control unit or on the local keypad. If necessary, level the projector from side to side by turning the adjustable feet in or out.
