According to our default config state, we will base on which interface the customer would like to go to.
If would like to go via WLAN, then the steps are as below:
-
First, configure the wireless client; How to do so can be found here: KB2265
-
Configure Buttons Connect To to the corp Access Point (AP).
-
Make sure LAN is not connected.
-
Pair the Button.
-
Validate connection works then connect LAN and try again.
However, if we would like to go via LAN, the steps are as below:
-
First, configure network authentication if required.
-
Configure Buttons Connect To to the corp AP.
-
Pair the Button.
-
Validate connection works.
-
Configure Wireless Client and try again.
Note: 192.168.2.x is used by the Wi-Fi (wlan0) during the initial setup and will result in IP conflicts with eth0 (in your LAN). If you are using DHCP for the Base Unit, you will need to switch to a manual IP, not in this range.
